Atx Power Connectors - Asus E2938 Hardware User Manual

8. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default , the pin labeled "Chassis Signal" and " Ground" are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
COMMANDO
COMMANDO Chassis intrusion connector
9.

ATX power connectors

(24-pin EATXPWR, 2 x 4-pin EATX12V)
These connectors are for ATX power supply plugs. The power supply plugs
are designed to fit these connectors in only one orientation. Find the proper
orientation and push down firmly until the connectors completely fit.
COMMANDO
COMMANDO ATX power connectors
•
•
2-32
®
EATX12V
®
Make sure to remove the cap on the EATX12V connector before connecting
an 8-pin EPS +12V power plug.
Use only either a 4-pin EATX12V or an 8-pin EPS +12V power plug for the
EATX12V connector.
CHASSIS
(Default)
+5V Standby
Chapter 2: Hardware information
EATXPWR
+3 Volts Ground
+12 Volts +5 Volts
+12 Volts +5 Volts
+5 Volts
Power OK -5 Volts
Ground Ground
+5 Volts Ground
Ground Ground
+5 Volts PSON#
Ground Ground
+3 Volts -12 Volts
+3 Volts +3 Volts