American Dynamics SpeedDome Ultra VII RAS917LS Configuration page 85

Day/night camera dome
Table of Contents

Advertisement

Additional Manchester Commands
The following tables summarize the special commands available when using the dome in a
Manchester network. These commands are available when you enter the number listed and press the
Set Preset or Call Preset button on the controller.
Set Commands
This table describes the functions that can be performed when you enter the number listed then press
the Set Preset button. The keyboard must be in programming mode to perform these functions.
If you want to ...
Reset the Dome
Activate / Deactivate V-phase delay setting adjustment
Cancel Pattern Programming
Save Pattern Programming
Program Pattern 1
Program Pattern 2
Program Pattern 3
Call Commands
This table describes the functions that can be performed when you enter the number listed then press
the Call Preset button.
If you want to ...
Resume Auto Focus / Auto Iris
Rotate dome 180° from current position ("flip")
Activate/Deactivate IR mode
Repeats following pattern
Run Pattern 1
Run Pattern 2
Run Pattern 3
2
This command changes the IR Mode setting on the Camera Functions menu. See Chapter 3 for information.
Manchester Command Summary
Use ...
65 Set Preset
67 Set Preset
68 Set Preset
69 Set Preset
70 Set Preset
71 Set Preset
72 Set Preset
Use ...
66 Call Preset
67 Call Preset
2
68 Call Preset
69 Set Preset
70 Set Preset
71 Set Preset
72 Set Preset
B–3

Advertisement

Table of Contents
loading

Table of Contents