American Dynamics SpeedDome Ultra VII RAS917LS Configuration page 106

Vicon Command Summary
The following table lists the Vicon controller key sequence to control the indicated SpeedDome Ultra
VII functions.
If you want to ...
Set Auto Iris ON/OFF
(LED indicates Auto Iris state: ON = AUTO)
Set Auto Focus ON/OFF
(LED indicates Auto Focus state: ON = AUTO)
Goto Presets
Program Presets
Run PEEL Pattern and Repeat
Rotate dome 180° ("Flip")
Start Pattern 1-3 Definition
End Pattern Definition
Review Pattern
Accept Pattern
Run Pattern 1-3
Repeat Pattern 1-3
Set Pattern to Peel
Vphase Dome
Note: The A/I LED blinks indicating that you are in
the vphase mode. Enter key sequence again to turn
vphase adjustment off. The A/I LED stops blinking
and indicates Auto Iris State.
Start Dome Configuration Menu
See Operating the Dome Configuration Menu on page
F–3.
Turn IR Mode On
Turn IR Mode Off
F–2
Use ...
A/I Toggles state
Press and Hold L-Spd
A/P Toggles state
Run/Pgm switch to RUN
Enter 1-79 Enter
Run/Pgm switch to PGM Enter 1-79
Enter
AUX5
AUX6
Run/Pgm switch to PGM Enter 80-
82 Enter
Run/Pgm switch to PGM Enter 86
Enter
Run/Pgm switch to PGM Enter 87
Enter
Run/Pgm switch to PGM Enter 88
Enter
Run/Pgm switch to RUN Enter 80-
82 Enter
Run/Pgm switch to RUN Enter 83-
85 Enter
Enter 89 Enter
Run/Pgm switch to PGM Enter 93
Enter
•
Pan Right to increment
•
Pan Left to decrement
Enter 94 Enter
Run/Pgm switch to PGM Enter 95
Enter
Run/Pgm switch to PGM Enter 96
Enter
SpeedDome Ultra VII Day/Night Operator's Manual