Card Remote Control - Aiwa CDC-X927M YUC Operating Instructions Manual

CARD REMOTE
CONTROL
Names of parts
BAND
CD
REW
DOWN
1 BAND button
2 TAPE button (This button is not available with this
unit.)
3 CD button
4 CD-CH button (CD changer only)
5 SKIP f/REW button
6 SKIP g/FF button
7 PS (preset) button
8 TUNING/DISC UP/DOWN buttons
9 VOLUME +/- buttons
Preparations
A lithium battery is installed in the remote control at the
factory.
Before you use the remote control, be sure to remove
the insulating sheet by simply pulling it out.
Remote control (back)
Insulating sheet
TAPE
CD-CH
SKIP
FF
TUNING / DISC
UP
VOLUME
Replacing the battery
1 Insert the tip of a pointed object A into the hole B
and pull out the battery holder to remove the lithium
battery (CR2025).
Remote control (back)
Battery holder
2
Install a new lithium battery (CR2025) with the )
side facing up in the battery holder.
3
Push the battery holder into the unit until it clicks.
CAUTIONS
• Keep the lithium battery out of the reach of children. If
swallowed, consult a doctor immediately.
• To prevent a short circuit, never pinch the battery with
pliers, etc.
6
ENGLISH