2.3 Self test pattern
The monitor may display a three colors test pattern. This is to indicate that the
monitor is functioning properly, but the computer' s video signal is not reaching
the monitor. In this case, please make sure the video cable is properly connected.
The test pattern will disappear when the monitor is able to receive the video signal.
However, if the test pattern does not display all three colors (blue, green and red),
the monitor is not functioning properly. Please contact your local dealer for
2.4 Safety protection
The safety protection function is protecting for the monitor itself. When frequency
of video signal from computer' s was out of range, (please refer to monitor
"specifications") The monitor will protect by itself and a warning message of OSD
will appear on the screen, warning you to resetting monitor type on your computer.
2.5 Timing guide
This multi-scanning monitor can automatically detect and display several video
modes. If the monitor recognizes one of preset timing signals, it will reset that
mode and any stored display adjustments you have made.
The factory preset modes as indicated in the following table
(dots x lines
Horizontal Frequency (KHz)
: Vertical Frequency (Hz)
(dots x lines)
3. Technical information
3.1 Products specifications
Picture tube (flat Screen CRT)
Surface / transmission:
Maximum viewable area
Display size (factory setting)
Power supply (universal)
Display Analog Input
Unit dimension (W x H x D)
Plug and Play)
NOTE: All technical specifications are subject to change without notice.
17-inch (43.18 cm) diagonal
Tinted screen glass non-glare, black matrix
16.02" (40.69cm) diagonal
310 mm (H) x 230 mm (V)
12.20 inch (H) x 9.06 inch (V) ( Adjustable)
AC 100-240V，60/50 Hz
110 watts maximum.
Video: Analog 0.7Vp -p / 75 Ohms
Sync. : Separate sync. TTL level
Unlimited Number of colors
(depends upon video card)
410 x 412 x 420 (mm)
5 C~40 C (41 F to 104 F)
-20 ~60 C (-4 F to 140 F)