Aim K-M-P - GCU2 Quick Start Manual

Advertisement

AiM InfoTech
K-M-P - GCU2
Release 1.00

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the K-M-P - GCU2 and is the answer not in the manual?

Questions and answers

Summary of Contents for Aim K-M-P - GCU2

  • Page 1 AiM InfoTech K-M-P - GCU2 Release 1.00...
  • Page 2 K-M-P GCU-2 interface. To correctly communicate with the AiM device, it is necessary to check if the module is set with the following default parameters. Refer to the manufacturer for additional details on the configuration procedure.
  • Page 3 Wiring connection These modules feature a bus communication protocol based on CAN, this data stream is accessible through a 2-way DTM06-2S-E007 connector (right picture below) located on the universal loom or through the main 37-way connector of the GCU-2. In this case the mating part AS614-35SN is pictured below (left), and the connection table for both options follows.
  • Page 4 • ECU Model: GCU2 (Only RS3 – CAN2 Stream) If there is only the AiM device connected to this module, enable the CAN Bus 120 Ohm Resistor. “KMP – GCU2” protocol Channels received by AiM loggers configured with “KMP - GCU2” protocol are:...
  • Page 5 VP SWITCH Paddle switch EMERG SW Emergency switch active VC GEAR Gear number VC RPM RPM Vx Downshift RPM Throttle position NEUTRAL Neutral switch active SHIFT STATUS Shift status AUTOCALIB ST Autocalibrationstatus CLUTCH FLAG Clutch active CLUTCH PRESS Clutch pressure AUTOSHIFT FLAG Autoshift flag SHIFT LIGHT...

Table of Contents