Page 1
AP PL I ANC ES FO R L I VI NG CAGH32 OPERATION MANUAL...
Page 2
ARTUSI Family. This instruction manual has been specially created to inform you of the full range of features your ARTUSI appliance has to offer and serves as an introduction to getting the very best out of your ARTUSI appliance.
Page 3
Preface Thank you for choosing our gas cooktop. To use this appliance correctly and prevent any potential risk, read these instructions before using the appliance. Keep these instructions in a place where you can find them easily. If you are unsure of any of the information contained in these instructions, please contact our customer care centre.
contents Preface Safety Warning Safety Instructions Installation Child and People Safety During Use Cleaning and Service Environmental Information Instructions for use and maintenance Description of the appliance How to Use the appliance Safety and Energy saving advice Cleaning and Maintenance Technical instructions Using instructions Positioning...
afety nstructions Please take the time to read this Instruction anual before installing or using the appliance. accident caused by misuse in advance, and use the appliance more conveniently. Danger/Warning Neglect of this mark may result in minor personal injury Caution or property damage.
Page 6
nstallation Warning accordance with regulations in force gas and electrical supply complies and only used in a well ventilated with the type stated on the rating space. plate. o not use this appliance as a space heater. must be installed in such a way that they do not touch any parts or the appliance.
hild and People afety Warning The appliance gets hot when it is in use. Children should be kept away until it has cooled. Caution from using the appliance safety without supervision or instruction by a responsible person to ensure that they can use the appliance safety.
uring se Warning Burner panel is not designed to operate from food. an external timer or separate remote control system. comes contact with water. Do not operate this appliance with wet hands. the appliance become hot when they similar as the ends could touch the are in use, take all due precautions.
Page 9
uring se materials aerosols may be affected by heat and in the storage drawer near this should not stored above or below the appliance. appliance. this appliance while it is in operaiton. ‘ ’ position when not in use. Caution pots or pans.
leaning and ervice Warning repaired cleaning agents. or serviced by an authorised Service Engineer and only genuine approved spare parts should be used. Caution and cooled. clean the appliance. Environmental Information with due regard to safety and the environment. unusable, by cutting off the cable. orrect is osal of This roduct...
escription of the appliance Dimension Ignition Electric Burner Top Plate Model supply Connection Feature (W*D*H) device tianless CAGH32X teel Continuous 220-240Vac, Rapid (1), Ignition 520*300*90 G1/2 thread 50Hz-60Hz, Auxiliary (1) Type CAGH32B Glass...
Page 12
escription of the appliance ccessories Sponge (2 ) Pressure regulator (1) Bracket (2 ) (2 ) Pressure joint(1) Screw (2 ) Instruction Elbow (1) Manual (1) ow to se the appliance Black circle: gas off Large flame: maximum setting Small flame: minimum setting The minimum setting is at the end of the anti clockwise rotation of the control handle.
Page 13
ow to se the appliance Automatic ignition with flame failure safety device The appliance is fitted with a flame failure safety device on each burner, which is designed to stop the flow of gas to the burner head in the event of the flame going out.
afety and Energy saving advice - The diameter of the bottom of the pan should correspond to that of the burner. of the burner. o not use small diameter cookware on large lways use cookware that is burners. suitable for each burner, to avoid The flame should never come up the sides of wasting gas and discolouring the the cookware.
Page 15
leaning and aintenance com letely cool etal rush ylon rush oft cloth cidic lkali Edible etergent eutral etergent brasive Thinner en ene water. For stubbon soiling, soak beforehand. the risk of corrosion. normal because of the high temperatures. Each time the appliance is used these parts should be cleaned with a product that is suitable for stainless steel.
Page 16
leaning and aintenance from the top plate. cloth and wipe dry with a clean cloth. blocked. .Place the flame spreader on to the burner cup so that the ignition device and the flame supervision device e tend through their respective holes in the flame spreader.The flame spreader must click into place correctly.
sing instructions Warnings e installed and connected in accordance ith current iance insta ation rease cranes roduced at the factory to meet the re uirement of all life hob.
Positioning CLEARANCES REQUIRED CUTOUT SIZE AND CLEARANCES WHEN FITTING WITH A COOKER HOOD 57mm This a liance is to e uilt into a itchen unit or or to ro iding the follo ing minium distances are allo ed The periphery of the nearest burmer must be a minimum distance of 200mm from combustible surface.
Installing the appliance appliance upside down and place it on a cushioned mat. supervision devices are not damaged in this operation. 2. Apply the sponge provided around the edge of the appliance. T NT dditional to the sponge around the edge of the appliance ensure an additional strip is applied on each side as per the diagram.
Page 20
as onnection Turn off power for safety and appliance protection. Close middle valve to prevent gas leakage. Keep away from inflammable materials around appliance. Before work, put on gloves. CAUTION Cool off the appliance for a while right after using appliance for your safety because you can get burners by high temperature from the appliances.
Page 21
as onnection This installation must conform with the following: ■ Manufacturer’s Installation instructions ■ Local Gas Fitting Regulations ■ Municipal Building Codes ■ Refer to AS/NZS 5601.1 for Gas Installations ■ S.A.A. Wiring Code ■ Local Electrical Regulations ■ Any other statutory regulations re arin to insta .
as onnection ■ ■ ■ Gas Connection Install in accordance with relevant gas standards and/or codes of practice applicable. Connect the elbow fitting to the appliance gas manifold connection, and check that seals between the elbow and manifold connection are in place and in good condition. For Natural gas: connect the natural gas appliance regulator (pictured opposite) with integral test point using approved gas thread tape or compound to the elbow...
Page 23
as pecification 11.8MJ/h 4.3MJ/h Universal LP Gas 0.90 0.58 2.75kPa 1.50 0.93...
Electrical onnection This appliance is designed to be connected to a electricity supply. - Green/yellow = Earth - Blue = Neutral - Brown = Live Switch 1 Switch 2 AC INPUT IGNITION When the power cord is damaged it must be replaced by the manufacturer to produce, customer service agent or similarly qualified personnel.
as adjustment hange the in ector of the urners. Remove the pan support, Burner lid and Flame spreader. Unscrew the injector using a 7mm box spanner and replace it with the stipulated injector for new gas supply. Carefully reassemble the all components. After injectors are replaced, it is advisable to strongly tighten Injector...
Trouble shooting Pro a le cause Solution Pro lem o park. heck the electricity supply. ot ignited The burner lid is badly assembled. ssemble the lid correctly. pen the gas supply The gas supply is closed. completely. adly ignited The gas supply is not completely pen the gas supply completely.
Page 27
O ce: 2. What is not Covered by the Warranty. 48-50 Moore Street, Leichhardt N.S.W 2040 The Warranty does not apply if an artusi product Post: is defective by a factor other than a defect arising Locked Bag 3000, Annandale, N.S.W 2038...
Page 28
Last Name: First Name: Address: State: Postcode: Email: Home Phone: Mobile: Purchase Date: (Please attach proof of purchase to validate warranty) SERIAL NUMBER MODEL NUMBER (if you cannot locate the serial number please call ARTUSI on 1300 694 583) 01032014...
Page 30
Product dimensions indicated in our literature is indicative only. Actual product only should be used to define dimension cutouts. Distributors, and retailers are not agents of ARTUSI and are not authorised to bind ARTUSI by any express or implied undertaking or representation.
Need help?
Do you have a question about the CAGH32 and is the answer not in the manual?
Questions and answers