Macro - One For All Urc-7140 Manual

You can program your ONE FOR ALL to issue a sequence of commands at the press of one single key. Any sequence of commands you regularly use can be reduced to one key press for
your convenience.
For example, you may want to create the following macro:
1st command: dvd --> STOP
2nd command: dvd --> OFF
3rd command: tv --> OFF
To set up the Macro mentioned above on the e.g. "Red" key on your ONE FOR ALL:
1
3 sec.
Press and hold magic for 3 seconds until a mode indicator (Blue LED) stays lit.
2
Press 9 9 5.
3
Press the key to which
the function will be
assigned (e.g. red key).
4
< select >
Select the
corresponding
device e.g. DVD
5
Press the STOP key
6
Press the POWER key
x2
--> The blue LED will blink twice.

Macro

7
Select the
corresponding
device e.g.TV
8
Press the POWER key
9
Press and hold magic for 3 seconds --> The blue LED will blink twice and then switch off.
Congratulations! You have successfully programmed a macro on the "red" key.
NOW, when you press the red key: 1st: dvd will STOP, 2nd: dvd switches OFF,
3rd: tv switches OFF. The remote will do this in every device mode whenever you
press the red key.
Press the red key
How to reset the macro key to obtain its original function?
1) Press and hold magic for 3 seconds until a mode indicator (Blue LED)
stays lit.
2) Press 9 9 5.
3) Press the corresponding macro key (e.g. the red key).
4) Press and hold magic key for 3 sec. --> The blue LED will blink twice.
4
< select >
3 sec.
STOP
& OFF
DVD DVD
Command 1: dvd STOP
Command 2: dvd OFF
Command 3: tv OFF
OFF