Sony Handycam DCR-DVD105E Operating Manual page 20

Step 2: Charging the battery pack (continued)
5
The CHG (charge) lamp turns off
when the battery is fully charged.
Disconnect the AC Adaptor from
the DC IN jack on your camcorder.
• Disconnect the AC Adaptor holding both
your camcorder and the DC plug.
To remove the battery pack
Slide the POWER switch to OFF (CHG).
Slide the BATT (battery) release lever and
remove the battery pack.
BATT (battery)
release lever
• When you remove the battery pack, make sure
that none of the respective lamps of the POWER
switch (p.23) is on.
When storing the battery pack
Use up the battery pack completely if you do
not intend to use it for a long time (p.135).
To use an outside power source
Make the same connections as you do when
charging the battery pack. The battery pack
will not lose its charge in this case.
Charging time (full charge)
Approximate time (min.) required when you
fully charge a fully discharged battery pack.
Battery pack
NP-FP50 (supplied)
NP-FP70
NP-FP71
NP-FP90
20
Charging time
125
155
170
220
Recording time
Approximate time (min.) available when you
use a fully charged battery pack.
For DCR-DVD105E/DVD605E
Continuous
Battery pack recording
time
NP-FP50
(supplied)
NP-FP70
NP-FP71
NP-FP90
For DCR-DVD205E/DVD705E
Continuous
Battery pack recording
time
NP-FP50
(supplied)
NP-FP70
NP-FP71
NP-FP90
Typical
recording
time*
100 045
115 050
215 095
240 110
255 115
290 130
385 175
435 195
Typical
recording
time*
080 040
085 040
090 045
170 085
185 090
190 095
200 100
220 110
230 115
300 150
335 165
345 170