Kenwood STZ-RF200WD Instruction Manual page 12

Installing the unit
Installation layout
Switch
Front
camera
• This installation layout is for reference. Actual installations will vary by motorcycle model.
• Main unit
Install the main unit underneath the seat.
  W hen fastening the main unit to the vehicle, check that there is adequate room to open the SD card
slot side door.
  T he included double-sided tape must be used when fastening the
main unit to the vehicle.
• The included double-sided tape must be affixed to the bottom (the
flat surface) of the main unit as shown in the image on the right.
• Before installing the unit with the included double-sided tape, select a flat location on the vehicle,
wipe away any dirt or grease on the installation location with a commercially available cleaning
cloth, and install the unit after the location has dried. Reusing tape or using general purpose
double-sided tape for installation will provide less adhesive power and presents a risk of the
unit falling off.
• Do not install in locations that will be subject to high temperatures (near the engine, muffler, etc.)
or high pressures (when the suspension bottoms out while someone is on the bike).
Main unit
GPS antenna
In order to correctly display the
orientation of the G sensor chart
of the PC viewer software*, attach
the main unit with the cable side
facing the front of the vehicle.
* Front and back (GX), left and
Rear camera
12
right (GY), top and bottom (GZ).
Double-sided tape
Double-sided tape