Other Hookups - Sony STR-DA50ES Operating Instructions Manual

Other Hookups

DIGITAL ANTENNA TV/LD DVD
DVD IN
COAXIAL
S-VIDEO S-VIDEO
FM
IN IN
75Ω
COAXIAL
VIDEO VIDEO
DVD IN OPT
y
AUDIO AUDIO
TV/LD IN OPT
IN IN
CD IN OPT
AM
MD/DAT IN OPT
IN IN
SIGNAL GND
MD/DAT OUT OPT
y
PHONO CD
The configuration, shape, and number of AC outlets on the rear panel
*
varies according to the model and country to which the receiver is
shipped.
S-LINK CONTROL A1 hookup
• If you have a S-LINK CONTROL A1-compatible
Sony CD player, tape deck, or MD deck
Use a CONTROL A1 cord (not supplied) to connect the
S-LINK CTRL A1 jack on the CD player, tape deck, or
MD deck to the S-LINK CTRL A1 jack on the receiver.
Refer to the separate manual "CONTROL-A1 Control
System" and the operating instructions supplied with
your CD player, tape deck, or MD deck for details.
Note
If you make CONTROL A1 connections from the receiver to an
MD deck that is also connected to a computer, do not operate
the receiver while using the "Sony MD Editor" software. This
may cause a malfunction.
• If you have a Sony CD changer with a
COMMAND MODE selector
If your CD changer's COMMAND MODE selector can
be set to CD 1, CD 2, or CD 3, be sure to set the
command mode to "CD 1" and connect the changer to
the CD jacks on the receiver.
If, however, you have a Sony CD changer with VIDEO
OUT jacks, set the command mode to "CD 2" and
connect the changer to the VIDEO 2 jacks on the
receiver.
S-LINK CTRL A1
VIDEO 2 VIDEO 1 MONITOR
S-LINK
CTRL A1
FRONT
S-VIDEO S-VIDEO S-VIDEO S-VIDEO S-VIDEO
L
OUT IN OUT IN OUT
VIDEO VIDEO VIDEO VIDEO VIDEO
R
AUDIO AUDIO AUDIO AUDIO
OUT IN OUT IN
L
B FRONT
R
REC OUT IN REC OUT IN
R L
L
R
MD/DAT TAPE
Required cords
CONTROL A1 connecting cord (not supplied)
Black
5.1 INPUT PRE OUT
REAR CENTER FRONT REAR WOOFER CENTER
L
R
WOOFER
SPEAKERS
A REAR CENTER
R L R L
IMPEDANCE USE 4–16Ω
Connecting the AC power cord
Before connecting the AC power cord of this receiver to a
wall outlet:
• Connect the speaker system to the receiver (see page
13).
• Turn the MASTER VOLUME control to the leftmost
position (0).
Connect the AC power cord(s) of your audio/video
components to a wall outlet.
If you connect other audio/video components to the AC
OUTLET(s) on the receiver, the receiver will supply power
to the connected component(s), allowing you to turn the
whole system on or off when you turn the receiver on/off.
Caution
Make sure that the total power consumption of the component(s)
connected to the receiver's AC OUTLET(s) does not exceed the
wattage stated on the rear panel. Do not connect high-wattage
electrical home appliances such as electric irons, fans, or TVs to
this outlet.
Black
AC power cord
AC OUTLET*
AC OUTLET
+
IMPEDANCE
SELECTOR
–
4 Ω 8 Ω
To a wall outlet
b
11 GB