Installation Warnings - Invacare 6375 User Manual

3.2 Removing/Installing Fixed Wheel Leg Extensions
 • To remove the fixed wheel leg extensions, reverse this procedure.
• For this procedure, Fefer to FIGURE 2.
• Walker Wheel Kit Model 6375 can only be used with the 6291-HDA Walker.
• The existing front leg extensions will not be reassembled to the walker when using the 6375
Walker Wheel Kit.
1. Press the snap button on the walker frame and remove the existing front leg extension.
Position the wheel attachment marked "L" for left on the left walker frame, and the wheel

attachment marked "R" for right on the right of the walker frame. Refer to FIGURE 2.
2. Press the snap button on the walker frame and slide the fixed wheel leg extension to the proper height
adjustment. Allow the snap button to engage into the height adjustment hole.
 There will be an audible "click".

INSTALLATION WARNINGS

• Ensure the snap buttons fully protrude through adjustment holes of each fixed wheel leg
extension.
• The fixed wheel leg extensions should be adjusted so the walker is level. If an even height
cannot be achieved, adjust the leg extensions so that the rear of the walker is no more than
one inch lower than the front.
3. Repeat STEPS 1 and 2 to install the opposite fixed wheel leg extension.
Fixed Wheel Leg
Extension "R"
Part No 1167434
Right
FIGURE 2 Removing/Installing Fixed Wheel Leg Extensions
Fixed Wheel
Leg Extension
Left
Adjustment
Rear Leg Extension with Glide Tip
Existing Front Leg Extension
(remove and replace with Fixed Wheel Extension "L")
3
Details
Height
Holes
Right is marked "R"
Fixed Wheel Leg Extensions
Left is marked "L"