About The Battery - Honeywell Multi-Bay Battery Charger Instructions Manual

For rp2, rp4 series mobile printer batteries
Table of Contents

Advertisement

About the Battery

Use only Honeywell Li-ion battery packs in this
device. Use of any non-Honeywell battery may result
in damage not covered by the warranty.
Battery Recommendations
• Batteries are shipped approximately 30% charged or less and
should be fully charged for maximum charge capacity.
• The battery is a lithium ion cell and can be used without a full
charge, and can also be charged without fully discharging
without impacting the battery life. There is no need to perform
any charge/discharge conditioning on this type of battery.
• Do not disassemble the battery. There are no user-serviceable
parts in the battery.
• Do not allow metallic conductive objects to contact battery
terminals. Do not short-circuit a battery or throw it into a fire;
it can explode and cause severe personal injury.
• Improper battery use may result in a fire, explosion, or other
hazard.
• Although your battery can be recharged many times, it will
eventually be depleted. Replace it after the battery is unable to
hold an adequate charge.
• If you are not sure if the battery or charger is working properly,
send it to Honeywell International Inc. or an authorized service
center for inspection. Refer to
additional information.
Technical Assistance
for

Advertisement

Table of Contents
loading

Table of Contents