Table of Contents
Advertisement
ZOOM
ZOOM
HZOOM
VZOOM
H POS
V POS
IMAGE FLIP
IMAGE FLIP
NONE
H FLIP
V FLIP
180° ROTATE
OSD FLIP
RESET
AUDIO
VOLUME
BALANCE
TREBLE
BASS
SURROUND
MULTI PICTURE AUDIO
LINE OUT
AUDIO INPUT
AUDIO DELAY
RESET
SCHEDULE
OFF TIMER
SCHEDULE SETTINGS
SCHEDULE LIST
*1: This function depends on which option board you use.
The image can be expanded/reduced.
NOTE: The expanded image which is outside of active display area is not shown. The reduced
image may have some image degradation.
Maintains the aspect ratio while zooming.
Amount of horizontal zoom.
Amount of vertical zoom.
Horizontal position.
Vertical position.
NOTE: When the ASPECT is DYNAMIC, the image will be changed to FULL image before
IMAGE FLIP, then start to IMAGE FLIP. This function is not available when MOTION in SCREEN
SAVER or ROTATE is "ON".
When selecting IMAGE FLIP except for NONE, following functions are released:
MULTI PICTURE MODE, TEXT TICKER, STILL, POINT ZOOM and ROTATE.
When input signal is Interlace, the image may be disturbed.
Display the inverse image right-left, up-down or rotation.
Press + or - to select.
Normal mode.
The image inverts right-left.
The image inverts up-down.
The image rotates 180 degrees.
Determines the OSD display direction.
If "ON" is selected, OSD will invert depending on the image.
Resets "ADJUST" settings back to factory settings.
Increases or decreases output volume level.
Select "STEREO" or "MONO" of audio output.
If you select "STEREO", adjust the balance of L/R volume.
Press + button to move the stereo sound image to right.
Press - button to move the stereo sound image to left.
To accentuate or reduce the high frequency sound.
Press + button to increase TREBLE sound.
Press - button to decrease TREBLE sound.
To accentuate or reduce the low frequency sound.
Press + button to increase BASS sound.
Press - button to decrease BASS sound.
Artifi cial surround sound.
NOTE: LINE OUT is disabled when this function is set to "ON".
Selects source of MULTI PICTURE AUDIO.
NOTE: This function depends on MULTI PICTURE setting.
Selecting "VARIABLE" enables control of the line out level with the VOLUME button.
Selects audio input source LINE IN, DPORT, HDMI1, HDMI2, HDMI3, HDMI4, OPTION*
Enables to set the delay time to output the audio. DELAY TIME can be set between 0 and
100 milliseconds. "ON" activates this function.
Resets "AUDIO" options back to factory settings except VOLUME.
Sets the monitor to power off after a length of time.
A time between 1 to 24 hours is available.
Creates a working schedule for the monitor to use.
NOTE: If your schedule is across date, please set ON time and OFF time individually at Settings.
List of schedules.
English-24
-
-
-
NONE
-
-
-
-
OFF
-
40
CENTER,
STEREO
0
0
OFF
PICTURE 1
FIXED
1
.
Depends on
signal input
ON,
37 MSEC.
-
OFF/1 HOUR
-
-
Advertisement
Table of Contents
