Advertisement
1
1. Measure width of escalator.
2. Measure distance from comb strip to
face of escalator kick-plate where esca-
lator grip rail passes through.
3
3. Extend vacuum pick-up heads and
brushes on both sides of the 2240 un-
til each snaps into a position just under
width measured in step 1.
Pull pin to extend
Depress latch to
brush.
extend pick-up.
4
4. Align the 2240 with escalator and tilt
handle down. DO NOT SET ON ESCALA-
TOR AT THIS TIME.
Insure handle
2
spring bar locks
under base as
shown in photo.
5. On the side of machine shown above,
find hole in outrigger slide whose dis-
tance from the brush is just over that
measured in step 2. Place outriggers into
these holes.
6
6. Carefully slide the 2240 onto the
escalator insuring vacuum pick-ups or
brushes don't rub along escalator kick
panels.
7
7. Adjust the angle of the vacuum pick-
ups & brushes with the tilt-adjust knob at
the rear, base of the 2240.
5
8. Raise or lower support rollers as need-
ed to provide approximately 1/16" clear-
ance between tread and vacuum pick-up
heads. Adjustment is made by loosening
roller hardware in the order shown be-
low. Tighten in reverse order.
8
Advertisement
