FAX ONLY MODE:
FAX/TEL AUTO SW:
The receive mode will be displayed on the bottom left of the LCD.
02/15/2006 WED 06:11
(A) Receive mode
For details on the receive modes, see
Press [Stop/Reset] and follow any instructions on the LCD.
If ink has run out while receiving a fax, if ink level is low, if the <SIZE> setting is incorrect, or if the
<TYPE> setting is other than <PLAIN>, the fax is automatically stored in memory and
<RECEIVED IN MEMORY> is displayed. When the ink tank is replaced or the paper size setting
is corrected, the stored fax is printed automatically.
The machine can store up to approximately 150 pages* of faxes in memory.
If the memory becomes full, the machine cannot receive the remaining faxes. Print or
delete the documents stored in memory (see
77), and then contact the sender and have him/her resend them.
* When using ITU-T No.1 chart (Standard mode)
"If You Want to Receive Only Faxes Automatically with Your
Machine, or You Have a Dedicated Telephone Line for Fax Use
Only:" on page
"If You Receive Mainly Voice Calls and Sometimes Faxes, or
You Want to Receive Faxes Manually:" on page
"If You Want to Receive Voice Messages on Your Answering
Machine and Receive Faxes Automatically:" on page
"If You Want to Receive Faxes Automatically as well as Voice
Calls:" on page
"If You Have Subscribed to a Distinctive Ring Pattern
Detection (DRPD) Service with Your Telephone Company (US and
Canada only):" on page
"If You Want Your Machine to Automatically Switch between
Fax and Voice Calls by the Call Ring Patterns (Network Switch)
(This setting is not available in some countries and regions.):" on
"Receive Modes" on page
"Printing or Deleting a Document in Memory"