Make sure any glue, ink, correction fluid, or the like is completely dry before loading the
Remove all staples, paper clips, and the likes before loading the document.
Using the Platen Glass
Open the Document Cover.
Load your document on the Platen Glass.
Place your document face down on the Platen Glass.
Align the upper left corner of your document with the alignment mark on the upper left
corner of the Platen Glass.
The machine cannot scan the area within about 0.08" / 2 mm from the rear edge, and
within about 0.08" / 2 mm from the left edge of the Platen Glass.
You can also scan in originals that are up to 0.39" / 10 mm thick, such as books. Set them
on the Platen Glass in the same way as documents.
Gently close the Document Cover.