Furman PS8 R II Owner's Manual page 8

P S - 8 R I I - P O W E R C O N D I T I O N E R / S E q u E N C E R
remote signal line has a special feature:
Holding the REM line high for at least 4 seconds
(whether by an actual remote switch or by any
unit's front panel switch) will force all units to the
OFF state, putting them back in sync. This is the
only way to re-sync units other than disconnecting
AC power to all the units. Remember — operating
the front panel rocker switch does NOT affect
the stored state of the unit, even though it does
temporarily turn the outputs OFF.
STATuS TERMINAL
The STATuS terminal is an output that may be
used to illuminate an LED at the remote location
to indicate that power is available at the PS-8R
II's outlets. If it is high (+12V), the unit is ON (or
at least in the process of sequencing ON); if it is
low, the unit is OFF (or sequencing OFF). Simply
connect the indicator LED between STATuS
and GND (do not use a series resistor). If the
LED does not light when the switch is in the ON
position, check the polarity and reverse the LED
leads (if needed).
BLINKING DELAy 1 INDICATOR
In Maintained Mode, the DELAy 1 LED on the PS-
8R II blinks whenever the unit is OFF (the remote
switch is in the OFF position).In Momentary Mode,
the LED blinks if the "memorized" state is OFF.
t h r e e y e a r
l I M I t e d wa r r a n t y
Furman Sound, LLC., having its principal place
of business at 1997 South McDowell Blvd.,
Petaluma, CA 94954 ("Manufacturer") warrants
its PS-8R II Power Conditioner / Sequencer (the
"Product") as follows:
Manufacturer warrants to the original Purchaser
of the Product that the Product sold hereunder
7
will be free from defects in material and workman-
ship for a period of three years from the date of
purchase. The Purchaser of the product is allowed
fifteen days from the date of purchase to complete
warranty registration by mail or on-line at the Fur-
man website. If the Product does not conform to
this Limited Warranty during the warranty period
(as herein above specified), Purchaser shall notify
Manufacturer in writing of the claimed defects.
If the defects are of such type and nature as to
be covered by this warranty, Manufacturer shall
authorize Purchaser to return the Product to the
Furman factory or to an authorized Furman repair
location. Warranty claims should be accompanied
by a copy of the original purchase invoice show-
ing the purchase date; this is not necessary if the
Warranty Registration was completed either via
the mailed in warranty card or on-line website reg-
istration. Shipping charges to the Furman factory
or to an authorized repair location must be prepaid
by the Purchaser of the product. Manufacturer
shall, at its own expense, furnish a replacement
Product or, at Manufacturer's option, repair the
defective Product. Return shipping charges back
to Purchaser will be paid by Manufacturer.
THE FOREGOING IS IN LIEu OF ALL OTHER
WARRANTIES, ExPRESS OR IMPlIED, IN-
CLuDING BuT NOT LIMITED TO THE IMPLIED
WARRANTIES OF MERCHANTABILITy AND
FITNESS FOR A PARTICuLAR PuRPOSE.
Manufacturer does not warrant against damages
or defects arising out of improper or abnormal
use of handling of the Product; against defects
or damages arising from improper installation,
against defects in products or components not
manufactured by Manufacturer, or against dam-
ages resulting from such non-Manufacturer made
products or components. This warranty shall be
cancelable by Manufacturer at its sole discre-
tion if the product is modified in any way without
written authorization from Furman Sound. This
warranty also does not apply to Products upon