Download Table of Contents Print this page

Troubleshooting - Black & Decker GCO1200C Instruction Manual


Available languages
Table of Contents
• Unit will not start.
• Battery pack will not charge. • Battery pack not inserted into the tool. • Insert battery pack into
For assistance with your product, visit our website for the
location of the service center nearest you or call the BLACK+DECKER help line at
be hazardous.
Recommended accessories for use with your tool are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
The following accessories should be used only in the sizes specified below:
BITS, METAL DRILLING – Up to 3/8 in. (9.5mm); BITS, MASONRY DRILLING – Up to 3/8
in. (9.5mm); WOOD DRILLING – Up to 1/2 in. (12.7mm).
The RBRC® (Rechargeable Battery Recycling Corp oration) Seal on the
nickel cadmium, nickel metal hydride or lithium-ionbatteries (or battery
packs) indicates that the costs to recycle these batteries (or battery packs)
at the end of their useful life have already been paid by BLACK+DECKER. In
some areas, it is illegal to place spent nickel cadmium, nickel metal hydride
or lithium-ion batteries in the trash or municipal solid waste stream and the
Call 2 Recycle® program provides an environmentally conscious alternative.
Call 2 Recycle, Inc., in cooperation with BLACK+DECKER and other battery users, has
established the program in the United States and Canada to facilitate the collection of
spent nickel cadmium, nickel metal hydride or lithium-ion batteries. Help protect our
environment and conserve natural resources by returning the spent nickel cadmium,
nickel metal hydride or lithium-ion batteries to an authorized BLACK+DECKER service
center or to your local retailer for recycling. You may also contact your local recycling
center for information on where to drop off the spent battery. RBRC® is a registered
trademark of Call 2 Recycle, Inc.
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur


• Battery pack not installed properly.
• Battery pack not charged.
• Charger not plugged in.
• Surrounding air temperature
too hot or too cold.
The use of any accessory not recommended for use with this tool could
• Check battery pack
• Check battery pack
charging requirements.
• Plug charger into a working
outlet. Refer to "Important
Charging Notes" for more
• Move charger and battery
pack to a surrounding air
temperature of above 40
degrees F (4.5°C) or below
105 degrees F (+40.5°C).

Hide quick links:


Table of Contents

This manual is also suitable for:


Table of Contents