Viewfinder Normal Indications - Sony DXC-D35H/D35PH Operating Instructions Manual

Viewfinder Normal Indications

During normal operation, the following items can be
indicated in the viewfinder.
1 VTR operation status indication
2 TAKE/CUE indication a)
3 Recording time or time data
a), b), c)
indication
4 NG indication a)
a)
5 Clip mode indication
6 Clip remaining
a)
indication
7 Status display area
8 EZ FOCUS indication
c)
9 LOW LIGHT indication
0 Camera microphone output
indication c)
qa Audio recording level indicators
qs Tape remaining indication
The significance of each of the indications shown in
the figure is as follows.
1 VTR operation status indication
This indicates the VTR's current operation status
(REC, PLAY, etc.).
2 TAKE/CUE indication
This displays a TAKE or CUE indicator when using
the ClipLink function and recording with the DSR-1/
1P.
TAKE: When recording in Mark mode, this
indication appears when a Mark IN point is set
and disappears when the next Mark OUT point is
set.
CUE: When recording in Cue mode, this indication
appears for about 1 second when a cue point is set.
3 Recording time or time data indication
This shows the following values.
• When the REC TIME switch on the camera is in the
TTL position: The total recording time
• When the REC TIME switch on the camera is in the
DUR position: The duration of the current recording
cut
54
Chapter 4 Viewfinder Screen Indications and Menus
a), b)
REC TAPE NEAR END
TAKE TCG 12:34:56:00
NG AUTO BLACK
CLIPM
198
EZ FOCUS
:LOW LIGHT 99 04 01
SS :1/100 10:00
30-25
a), b), c)
a), b), c)
W:A
SKIN
-OK- EVS
F5.6
DRP 18dB
56ND
AM
BATT:14.4V
a) Displayed only when a DSR-1/1P is connected.
b) Displayed only when a PVV-3/3P is connected.
c) Whether or not to display can be selected by menu setting.
d) This is recorded over the picture being shot.
• With a VTR connected, when the REC TIME switch
on the camera head is in the OFF position and the
item TC IND in advanced menu page 6 is set to
"ON": A time data value from the VTR depending on
the DISPLAY switch settings on the VTR as shown
in the following table
DISPLAY switch
setting
COUNTER
TC
U-BIT
When using the DSR-1/1P, time data values appear
during playback, fast forward, rewind, or recording
review.
4 NG indication
An "NG" (No Good) indicator appears if you
designate a recorded scene as "NG" when using the
ClipLink function and recording with the DSR-1/1P.
qd VTR warning indication
qf White balance indication
qg SK/N DTL indication
qh EVS indication
qj Lens f-stop indication
qk Gain indication c)
ql Filter setting indication
w; Clock indication a), b), c), d)
wa Voltage/error indication
ws Shutter setting indication
Time data displayed
CNT: Tape transport time
TCG: a time code from the time code
generator
TCR: a time code from the time code
reader
UBG: a user bit value from the user
bit generator
a), b)
c)
c)
c)
c)
c)