Fujitsu Stylistic 5020 User Manual page 19

In the following table, a "blinking" LED flashes at the rate of once per second; an LED that is "blinking, slow" flashes at the
rate of one second on, five seconds off.
Icon Mode/State
Battery
• On State
• Idle Mode
• Suspend-to-RAM,
without AC adapter
• Suspend-to-RAM
with AC adapter
• Hibernate
(Save-to-Disk),
with AC adapter
• Off State
• Hibernate
(Save-to-Disk),
without AC adapter
HDD • On State (or
flashing)
Access
• Idle Mode
• Suspend-to-RAM
• Hibernate
(Save-to-Disk)
• Off State
Security
• On State
LED State
Green, continuous
Amber, continuous
Red, continuous
Red, blinking
Green, blinking slow
Amber, blinking slow
Red, blinking slow
Off
Green
Off
Green, continuous
(until password is
entered)
Table 1-2. System Status Indicators
G e t t i n g S t a r t e d
Remarks
Battery charge is between 50%-100%
Battery charge is between 13%-49%
Battery charge is between 0%-12%
There is a battery error.
Battery charge is between 50%-100%.
Battery charge is between 13%-49%.
Battery charge is between 0%-12%.
Battery is not installed, or system is off or in
Hibernate mode.
If battery is inserted during power off, LED blinks
amber for 4 seconds to detect battery. Battery
status is displayed for 5 seconds after that.
Displayed when hard disk drive is accessed.
Hard disk drive is not being accessed.
The Security Indicator lights (if a password was
set) when the system resumes from Off or
Standby modes. You must enter the password
that was set in the Security Panel before your
system will resume operation.
9