Fujitsu Stylistic 5010D User Manual page 73

Ocampa2_UG.book Page 63 Thursday, February 19, 2004 5:23 PM
Problem Possible Cause
Unavailable It takes too long to
retrieve the network
network
and display the
connection
connected
(continued)
computers.
Incorrect setting of IP
address
Communication Access control may
be disabled
is disconnected
soon after
connection to
the access point
Authentication
method may have
been entered
incorrectly
W i r e l e s s L A N U s e r ' s G u i d e
Possible Solution
Retrieve computers as follow:
1. Click [Start] button, then click [Search].
2. Click [Computers or people].
3. Click [Computers on the network].
4. Input the name of computer to be connected with in [Computer
name] and click [Search].
5. Double-click the icon of connected computer.·
Check the network setting.
"Setting the network" on page 57.
In case of using TCP/IP protocol, you can check IP address as follows:
1. Click [Start] -> [All programs] -> [Accessories] ->
[Command prompt].·
2. In [Command prompt] or [MS-DOS prompt] window, input
[IPCONFIG] command as follows, then press [Enter] key.
Example: In case of C drive being the hard disk:
C:\ipconfig [Enter]
Check that the IP address is correctly displayed:.
IP Address................: 10.0.1.3
Subnet Mask.............: 255.255.255.0
Default Gateway.........: 10.0.1.1
When IP address is displayed as [169.254.XXX.YYY] or [0.0.0.0],
IP address is not correctly fetched from the access point. In that
case, restart the computer itself. If the display is still unchanged,
check the setting of TCP/IP.
If [Cable Disconnected] or [Media Disconnected] is displayed
without showing IP address, check the setting of network name
(SSID) and network key. Also, set the network authentication
according to the access point.
Check the setting of "Enable network access control using IEEE
802.1X".Refer to "Assigning parameters" on page 55.
When restricting the access of wireless LAN clients using IEEE802.1X
authentication, put a check mark on "Enable network access control
using IEEE 802.1X".
When using at home, remove a check mark on "Enable network access
control using IEEE802.1X".
For the method of setting related with IEEE802.1X authentication, refer
to the access point manual.
Re-enter your WEP key and verify that your authentication method
(Open or Shared) is correct.
63