Memory Upgrade Module; Installing Memory Upgrade Modules - Fujitsu Lifebook T2010 User Manual

Fujitsu lifebook t2010: users guide
Hide thumbs Also See for Lifebook T2010:
Table of Contents

Advertisement

Memory Upgrade Module

Your Fujitsu LifeBook notebook comes with a minimum of 512 MB of high speed Double Data Rate
Synchronous Dynamic RAM (DDR2-533 SDRAM) factory installed. To increase your notebook's memory
capacity, you may install an additional memory upgrade module. The memory upgrade must be a dual-in-
line (DIMM) SDRAM module. To ensure 100% compatibility, purchase the SDRAM module only from
the Fujitsu web store at www.shopfujitsu.com

Installing Memory Upgrade Modules

1
Turn off power to your notebook, remove any power adapter (AC or auto/airline). Remove the battery.
2
Make sure that all the connector covers are closed.
3
Turn the notebook bottom side up, and remove the screws from the memory upgrade module compartment.
4
Slide the cover towards the battery compartment slightly, then lift it and remove it (Figure 20).
5
Remove the memory upgrade module from the static guarded sleeve.
6
Align the memory upgrade module with the part side up. Align the connector edge of the memory upgrade
module with the connector slot in the compartment.(Figure 21)
D
O NOT REMOVE ANY SCREWS FROM THE MEMORY UPGRADE MODULE COMPARTMENT EXCEPT THE ONES
SPECIFICALLY SHOWN IN THE DIRECTIONS FOR INSTALLING AND REMOVING THE MEMORY UPGRADE MODULE
T
HE MEMORY UPGRADE MODULE CAN BE SEVERELY DAMAGED BY ELECTROSTATIC DISCHARGE
MINIMIZE RISK TO THE MODULE
B
EFORE HANDLING A MEMORY MODULE
ELECTRICITY BUILT UP IN YOUR BODY
W
HEN INSTALLING OR REMOVING A MEMORY MODULE
. B
CONTACTS OR CHIPS
THE OIL FROM YOUR FINGERS COULD CAUSE A SHORT TO THE COMPONENTS
B
E SURE TO POWER DOWN YOUR SYSTEM BEFORE ADDING OR REMOVING MEMORY MODULES
SYSTEM IS IN HIBERNATE OR STANDBY STATES
IF POWER IS STILL AVAILABLE TO THE SYSTEM
86 - Memory Upgrade Module
.
,
OBSERVE THE FOLLOWING PRECAUTIONS
,
TOUCH A GROUNDED METAL OBJECT TO DISCHARGE STATIC
.
E CAREFUL NOT TO TOUCH ANY INTERNAL COMPUTER TERMINALS OR COMPONENTS
,
DATA COULD BE LOST OR THE MEMORY COULD BE DAMAGED
.
:
,
HOLD IT BY THE EDGE SO AS NOT TO TOUCH ANY
.
.
(ESD). T
O
;
. E
VEN IF THE

Advertisement

Table of Contents
loading

Table of Contents