Universal Serial Bus Ports; Microphone Jack; Headphone Jack; S-Video Out Port - Fujitsu Lifebook N3510 User Manual

L i f e B o o k N S e r i e s N o t e b o o k – S e c t i o n F o u r

UNIVERSAL SERIAL BUS PORTS

A Universal Serial Bus (USB) 2.0 port allows you to
connect USB devices such as game pads, pointing
devices, keyboards and speakers. USB 2.0 is downward-
compatible with USB 1.1 devices, so older USB devices
will work with these ports. USB 2.0 is a much faster
design, running forty times faster than USB 1.1.
Your LifeBook notebook has four USB 2.0 ports; three
on the back and one on the left side. To connect a USB
device follow these steps: (Figure 4-14)
Figure 4-14. Connecting a USB device
1. Align the connector with the port opening.
2. Push the connector into the port until it is seated.
Due to ongoing changes in USB
technology and standards, not all USB
devices or drivers are guaranteed to work.

MICROPHONE JACK

The microphone jack allows you to connect an external
mono microphone. Your microphone must be equipped
with a 1/8"(3.5 mm) mono mini-plug in order to fit into
the microphone jack of your LifeBook notebook. In
order to connect a microphone follow these easy steps:
(See Figure 2-5 on page 11 for location)
1. Align the connector with the port opening.
2. Push the connector into the port until it is seated.

HEADPHONE JACK

The headphone jack allows you to connect headphones
or powered external speakers to your LifeBook note-
book. Your headphones or speakers must be equipped
with a 1/8" (3.5 mm) stereo mini-plug. In order to
connect headphones or speakers follow these steps:
1. Align the connector with the port opening.
2. Push the connector into the port until it is seated
If you plug headphones into the head-
■
phone jack, you will disable the built-in
stereo speakers.
■ For information about using Dolby
Headphone, refer to "Using Dolby™
Headphone" on page 39
46

S-VIDEO OUT PORT

The S-Video port allows you to connect and use directly
any S-Video device, such as a VCR or television. The
S-Video standard provides for a higher quality picture
than NTSC or PAL. To connect an S-Video device,
follow these steps: (Figure 4-15)
1. Align the connector with the port opening.
2. Push the connector into the port until it is seated.
Figure 4-15. Connecting an S-Video device

EXTERNAL MONITOR PORT

The external monitor port allows you to connect an
external monitor. To connect an external monitor follow
these steps:
Figure 4-16. Connecting an external monitor
1. Align the connector with the port opening.
2. Push the connector into the port until it is seated.
3. Tighten the two hold-down screws, located on
each end of the connector.
.
TM
Pressing the [Fn] + [F10] keys allows you
to change the destination of your display
video. Each time you press the key combi-
nation, you will step to the next choice,
starting with the built-in display panel
only, moving to the external monitor only,
finally moving to both the built-in display
panel and an external monitor.