Resetting To The Factory Default Settings; Capturing An Image; Switching The Input Signal; Using The Assigned Function As Shortcut - Panasonic PT-AE3000U Operating Instructions Manual

Remote control operation

Resetting to the factory default settings

You can reset most of the customized settings
to the factory defaults by pressing DEFAULT
button of the remote control. Display the
required sub-menu or the menu items and
press the button again.

Capturing an image

Press the FREEZE button to capture the
image, and you can see it as a still picture while
the AV equipment are continuing. Press the
FREEZE button again to escape and return to
the continuing image.

Switching the input signal

You can switch the input method manually
by pressing the INPUT SELECT button.
Press the button several times or press I
H to cycle through the input methods as
follows. The actual projected image will be
changed in a while.
The graphical guidance will be displayed on the upper
right of the projected image and you can confirm the
selected input method which is highlighted in yellow. See
"INPUT GUIDE" on page 43.
COMPONENT 1 IN
COMPUTER IN
HDMI 3 IN
HDMI 2 IN

Using the assigned function as shortcut

You can access the assigned function in FUNCTION BUTTON menu as shortcut. See "FUNCTION BUTTON" on
page 42.
HDMI 1 IN
HDMI 2 IN
HDMI 3 IN
COMPUTER IN
COMPONENT 1 IN
COMPONENT 2 IN
S-VIDEO IN
VIDEO IN
BLANK
AUTO SETUP
CONTRAST
CONTRAST R
CONTRAST G
CONTRAST B
E
28 - NGLISH
NOTE:
While displaying the frozen image, you can enter the
AREA SELECT mode of the SPLIT ADJUST menu by
pressing the ENTER button. See "SPLIT ADJUST" on
page 33.
COMPONENT 2 IN
S-VIDEO IN
VIDEO IN
NOTE:
HDMI 1 IN
NORMAL
DYNAMIC
COLOR1
COLOR2
page 28
CINEMA1
CINEMA2
CINEMA3
SPLIT ADJUST
WAVEFORM AUTO ADJUST
page 42
LENS MEMORY LOAD
page 39
BRIGHTNESS
page 32
BRIGHTNESS R
BRIGHTNESS G
page 34
BRIGHTNESS B
• Some menu items are not available to reset by pressing
the DEFAULT button. Adjust each menu item manually.
COMPONENT (YP
COMPONENT 1 IN
from the equipment connected to
COMPONENT IN 1/
COMPONENT 2 IN
COMPONENT IN 2.
S-VIDEO signal from the equipment
S-VIDEO IN
connected to S-VIDEO IN.
VIDEO signal from the equipment
VIDEO IN
connected to VIDEO IN.
HDMI 1 IN
HDMI signal from the equipment
HDMI 2 IN connected to HDMI IN 1/HDMI IN 2/
HDMI IN 3.
HDMI 3 IN
COMPUTER (RGB) signal from the
COMPUTER IN equipment connected to
COMPUTER IN.
• If you select an unplugged input method, the guidance
will blink on and off several times.
• See "List of compatible signals" on page 50.
• See "Connections" on page 18.
P ) signals
B R
page 32
page 33
page 40
page 32
page 34