FujiFilm Finepix S3000 Owner's Manual page 46

6.4 INSTALLATION ON A Mac OS X
Pre-installation Checklist
I Hardware and software requirements
To run this software, you must have the hardware and software described below. Check your system before
you begin the installation.
Compatible Mac Power Macintosh G3
Power Macintosh G4, iMac, iBook,
Power Macintosh G4 Cube, or PowerBook G4
Operating System Mac OS X (compatible with version 10.1.5 to 10.2.6)
RAM 192 MB minimum , 256 MB or more recommended
Hard disk space Amount required for installation: 200 MB minimum
Amount required for operation: 400 MB minimum
(When ImageMixer VCD2 for FinePix is used: 2GB or better)
800 × 600 pixels or better, at least 32,000 colors
Display
(When ImageMixer VCD2 for FinePix is used: 1024 × 768 or better)
✽2
Internet connection
i To use the FinePix Internet Service or mail attachment function
An Internet connection and e-mail transmission software
i Connection speed: 56k or better recommended
✽1 Models with a USB port as a standard feature
✽2 Required to use the FinePix Internet Service. The software can still be installed even if you do not have an Internet connection.
N N
Note
i Connect the camera directly to the Macintosh using the USB cable (included). The software may not operate
correctly if you use an extension cable or connect the camera via a USB hub.
i Push the USB connector fully into the socket to ensure that it is securely connected. The software may not
operate correctly if the connection is faulty.
i Additional USB interface board is not guaranteed.
i On Macintosh computers, allocate at least 400 MB of virtual memory when RAW FILE CONVERTER LE is
used. If other applications will be used at the same time, allocate the additional amount required for those
90
applications also.
✽1 ✽1
, PowerBook G3 ,
I Functions not supported in FinePixViewer for Mac OS X
Function
PC Camera Not supported.
Online updating Information on updates can not be obtained using [Support] in the Internet menu.
Comment
6
91