Husqvarna QRT4281W User Manual page 19

Table of Contents

Advertisement

Problem
Door does not open easily.
Side panels of the appliance
are warm.
The lamp does not work.
There is too much frost and
ice.
There is too much frost and
ice on food products in the
refrigerator.
Water flows on the rear plate
of the refrigerator.
There is too much con‐
densed water on the rear
wall of the refrigerator.
Possible cause
You attempted to re-open
the door immediately after
closing.
This is a normal state
caused by operation of the
heat exchanger.
The lamp is in stand-by
mode.
The lamp is defective.
The door is not closed cor‐
rectly.
The gasket is deformed or
dirty.
Food products are not wrap‐
ped properly.
Temperature is set incorrect‐
ly.
Appliance is fully loaded and
is set to the lowest tempera‐
ture.
Temperature set in the appli‐
ance is too low and the am‐
bient temperature is too
high.
Food products are placed
too close to the temperature
sensor.
During the automatic de‐
frosting process, frost melts
on the rear plate.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
ENGLISH
Solution
Wait a few seconds between
closing and re-opening of
the door.
Make sure the appliance in‐
stallation is done according
to the instructions given in
this user manual.
Close and open the door.
Contact the nearest Author‐
ized Service Centre.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products bet‐
ter.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Keep a distance between
food products and the tem‐
perature sensor (a rectangu‐
lar indent in the right wall of
the refrigerator between the
glass shelves).
This is correct.
Open the door only when
necessary.
Make sure the door is closed
completely.
19

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Qrt4281x

Table of Contents