Select CREATE ACCOUNT.
Enter a user name, a password, an e-mail address and
select SIGN UP.
Tap NEXT STEP.
Follow the on screen checklist to ensure that your camera
is power connected and tap NEXT.
Select the camera from the list.
If you cannot find the camera ID on the list, please reset the
camera with the following procedure:
1. Switch the ON/OFF switch to ON.
2. Press and hold the RESET button on the underside of
the camera for 5 seconds, until you hear a beep sound.
3. Release the RESET button and wait for the camera to
complete the internal reset procedure.
4. After about 60 seconds you will hear two short beeps
and the green LED starts blinking.
Getting started: Working with devices for Android
Wait for up to five minutes. If the connection process takes
longer, tap CANCEL and try again.
Ensure that you have a good Wi-Fi network connection.
Once your camera is installed, you can rename it.
Tap START MONITOR to show the camera view.
Tap VIEW to show the camera view and the controls.
The Camera SSID is printed on the label on the bottom of the
Camera, for example: ID: Camera-1006fa
On your devices for Android
3.4 User Account and Camera Setup:
Working with iPhone
Install the application "Monitor Everywhere" from the
. Note: If you can't find the application, then use
Getting started: Working with iPhone
you will see: Camera-1006fa.
16/8/13 2:08 PM