3. Getting started - Connecting Devices
How does it work?
The Monitor Everywhere Server keeps track of the cameras.
When a user wants to access the camera, the server
authenticates the user and permits the user access to the
Connect the Camera to the power adapter and plug it into
a power socket. Wait until the camera LED changes to fast
blinking, which means that camera is in reset/setup state and
camera is ready for 'Camera Setup' registration. The Camera
must be within range of the Wi-Fi
Status of LED Indication:
- Reset / Setup state: fast blinking
- Unconnect state:
- Connect state:
View your camera from
any device remotely
router with which you want it
In general, there are three alternative ways to create user
account and camera setup:
With PC or
With devices for Android™ or
3.2 User Account and Camera Setup:
Working with PC or notebook
Attention for "Camera Setup mode via micro-USB
Turn on your PC.
Connect the one end of USB cable (shipped with package)
to the micro-USB port on camera and the other end to the
USB port on PC.
Plug an adaptor to the camera and the other end of adaptor
to the power outlet.
Switch the power switch on camera from OFF to ON.
Wait for 1 minute until camera emits two short beeps and PC
has detected the camera.
Run your web browser.
Type in the following link into address box.
'BLINK1.1' Setup page is displayed on the web browser
Select your choice whether is 'Windows Setup' or 'Mac
Then, you will be asked to run <Setup Blink> application.
Then, [log in] screen pops up.
Enter username and password if you have account .
Getting started: Working with devices for Android
16/8/13 2:08 PM