Table of Contents
Advertisement
Adjusting the flame
The burner can be variably adjusted
between the lowest and highest flame
by turning the control knob.
Since the outer portion of the flame is
much hotter than the center, the flame
should be set so that its tips do not
spread beyond the sides of the pan.
Flame tips which extend beyond the
sides of the pan are hazardous.
Turning off
^ Turn the control clockwise to "ß".
This stops the flow of gas and the flame
goes out.
Using the cooktop during a
power failure
If there is an interruption to the
electrical supply, the gas can be
ignited using a match.
^ Press the control knob down and turn
it counterclockwise to the ignition
position.
^ While holding down the knob, light
the gas at the burner with a match.
When the flame appears, keep the
control knob pressed in for
8 - 10 seconds to allow the Ignition
Safety Control to reach operating
temperature.
Operation
13
Advertisement
Table of Contents
