Table of Contents
Advertisement
RELAY UNIT TSAR-G2+
OPERATING MODES
Stairs light activation relay (necessary module SAR-12/24):
- This operating mode allows activation of the stairs light from the apartment. (
and from the
Dip1
to
Dip3
It will be activated by pressing the button located below the light con
of the ART 4 / ART 4 LITE monitor, in the main menu of the ART 7 / ART 7 LITE monitor by clicking on the icon of the
ART 7W monitor displayed on the screen in the main menu
terminal
or T-ART telephone (in standby and handset on the hook on T-ART telephone)
- See user manual for monitor
Mains
100~240Vac
Bus Monitors
SAR-G2+ configuration SW1 dip switch:
Light operating mode:
ON
Dip 4
to
ON.
1
2
3
4
Dip 1
to
Dip3 a OFF.
JP1 jumper: Leave in the pos. 2-3.
* ( ) Neutral point of the power supply of the stairs light is connected in series through the relay contacts of the SAR-12/24.
IMPORTANT: For the description, installation, configuration and programming of the system, see the corresponding manual.
Additional lock release activation relay (necessary power supply unit TF-104):
- This operating mode allows activation of a Golmar additional alternating lock release. This lock release is activated as lock
release 1 or lock release 2 and with the panel that has been assigned (through configuration in SAR-G2 see
a call or communication process.
It will be activated by pressing the button located below
respectively) shown on the
ART 7W monitor displayed on the screen o
- See user manual for
monitor/ audio terminal
100~240Vac
Important:
-If the door panel has the lock release 1 connected, lock release 2
must be connected to the SAR-G2+ relay unit.
-If the door panel has the lock releas 2 connected, lock release 1
must be connected to the SAR-G2+ relay unit.
Do not repeat the same lock release on both the panel and
the SAR-G2+ relay unit.
JP1 jumper: Leave in the pos. 2-3.
* ( ) The power supply of the lock release is connected in series through the SAR-G2 relay contacts.
IMPORTANT: For the description, installation, configuration and programming of the system, see the corresponding manual.
to
OFF n
i the configuration
or terminal
installed in the apartment.
FA-G2+
2
ART4/
ART4 LITE/
ART7
r pressing the
installed in the apartment
Mains
FA- 2+
G
Bus Monitors
SW1 dip
switch of the
i
displayed
or pressing the
2
SAR-G2+
SAR-12/24
2
2
Access
door
2
of corresponding icon
/ ART7 LITE monitor screen,
button
or
of the
.
Additional Vac
lock release
2
2
Light operating mode Set the
:
SAR-G2+).
on the screen in the settings menu
,
button
......
for 3 seconds
.
To stairs light
push button
2
* ( )
220Vca/ 1.8A máx.
panel
G2+
+,
or
(
lock release 1 or lock release 2
2
1
by clicking on the
corresponding
ART 1
terminal or T-ART telephone.
* ( )
2
2
SAR-G2+
TF-104
TF-104
2
Access
door
panel
2
+
3
Dip 4
to
ON
of the
ART 1
page 4
) during
icon of the
Mains
100~240Vac
G2+
Advertisement
Table of Contents
