Setting The Time Code - Canon XL H1 Instruction Manual

Setting the Time Code

Selecting the Frame Setting
In 60i and 30F mode, you can select between drop frame or non-drop frame time code.
MENU
SIGNAL SETUP
( 31)
Open the menu and select [SIGNAL SETUP]. Select the [TIME CODE] submenu and then
[FRAME SETTNG]. Select a setting option and close the menu.
When you select the [NON DROP] setting or when you select 24F frame rate in SD mode, "NDF" will appear
on the side panel display.
Selecting the Run Options
When recording in a mode other than 24F in SD mode, you can select from record run (REC-RUN),
record run preset (REC-RUN PS.) and free-run (FREE-RUN) time codes. In 24F (in SD) mode, you can
select from record run or record run preset. With record run, the time code runs only when you are
recording. With free run, the time code runs regardless of the operation of the camcorder.
You can select the start point for the free-run and the record run preset time codes.
MENU
SIGNAL SETUP
( 31)
1. Open the menu and select [SIGNAL SETUP]. Select the [TIME CODE] submenu and
then [COUNT-UP]. Select a setting option and close the menu.
[REC-RUN]: Close the menu.
[REC-RUN PS.], [FREE-RUN]: Continue the procedure below to set the start point.
2. Select [SET].
The hours display flashes.
3. Set the time code's starting value.
Turn the SELECT dial to set the value for the hours and press the SET button. The next field of the display
starts flashing. Set the value for the minutes, seconds and frames in the same way.
4. Close the menu.
About the time code display
- [REC-RUN]:
- [REC-RUN PS.]:
- [FREE-RUN]:
- External Time Code: The time code will be displayed in blue with an
- Time Code Hold:
- Playback:
When setting the free-run time code, the time code starts to run the moment you press the MENU
button in the middle of the setting, or when you press the SET button after setting the value for
"frames" in step 3.
To reset the time code to [00:00:00:00], select [RESET] in step 2.
58
TIME CODE
TIME CODE
The time code will be displayed with an
The time code will be displayed in blue with a
The time code will be displayed in blue with an
The time code will be displayed in blue with an
No time code display.
FRAME SETTNG•DROP
COUNT-UP•••••REC-RUN
next to it.
R
next to it.
P
next to it.
F
next to it.
E
next to it.
H