Hunter 20014-MW User Manual

READ AND SAVE THESE INSTRUCTIONS!
reach of children.
for any signs of damage. DO NOT use the product if the
cord has been damaged.
not in operation or while it is being cleaned.
DO NOT use water bottles greater than 22oz.
This product is intended for residential use only. DO
NOT use outdoors.
Initial Setup:
1. Unravel and straighten the cord before use.
2.
3. Use the adapter cap that came with
your humidi er and press it down over
the mouth of the water bottle rmly.
4. Turn your water bottle upside down
and insert into the water reservoir.
Failure to ensure the adapter cap is seated correctly may
cause the unit to leak water from the water bottle.
5. Connect the humidi er to a power outlet using a USB-C
cord (included) and a USB power adapter rated DC 5V
2A (not included).
Carrying bag
USB-C cord
20308-01
Personal Ultrasonic Personal Ultrasonic Personal Ultrasonic
Model
20014-MW
20014-MB
Adapter cap
Mist adjustment
button
Light on/off button
NOTE: This humidi er works at LOW
mist setting only if connecting to lower
rating USB power adapter.
NOTE: If you are using other USB-C
cord, please make sure it is less than 33" in length. The
mist level may be affected if using longer USB-C cords.
Operation:
1. To turn the humidi er ON, press the
"MIST" button. This will adjust the mist
output to LOW (blue light), MEDIUM
(yellow light), HIGH (purple light) and
OFF. The indicator lights on the top of the unit will
indicate the humidity level selected.
NOTE: You may turn the LED light off by pressing the
"LIGHT" button while the humidi er is still in operation.
2. To turn the humidi er OFF, press the "LIGHT" button to
make sure the LED light is ON, then press the "Mist"
button until the indicator lights turn off.
Maintenance:
1. Turn off the humidi er, disconnect the USB-C cord from the
humidi er and unplug the power adapter from the wall.
2. Remove the water bottle from the unit and remove the
adapter cap.
3. Empty the water from the bottle.
4. Rinse the adapter cap thoroughly with warm water.
Replace the water bottle if necessary.
5.
empty any remaining water.
6. Wipe any mineral deposits from the cover and base
with a soft cloth.
7. Replace the cover onto the base. Align
the notch on the cover with the groove
on the base. The mist exhaust should
be 45 to the right of the control
O
buttons.
Mist exhaust
Reservoir
cover
USB-C port
20201112
Transducer
Fan exhaust