Connecting The Turbocharger; Attaching The Support - ABB Turbocharger A130-M Original Assembly Instructions

Assembly Instructions / A130-M.. - A145-M
4 Installing the turbocharger / 4.6 Connecting the turbocharger
4.6

Connecting the turbocharger

Connect cable to speed sensor (86515).
u
Connect all gas, water and air lines according to the instructions of the enginebuilder.
u
Version with water-cooled bearing casing
Fit the water pipes according to the instructions of the enginebuilder.
u
Version with compressor wheel cooling
CAUTION
Failure of compressor wheel cooling
Any prolonged failure of the compressor wheel cooling will shorten the re-
placement interval of the compressor wheel.
Make sure there is an uninterrupted supply of cooling air during opera-
u
tion.
Fig. 10: Connecting the compressor cooling air intake
Remove the screw plug on the connection for the compressor wheel cooling (06) and fit
u
the cooling air line.
4.7

Attaching the support

Fig. 11: Attaching the support
If present: Attach support (61301) to engine support or to a connecting piece.
u
© Copyright 2020 ABB. All rights reserved. HZTL455311P0005_EN Rev.B July 2020