Setting Warmer Drawer Controls (If Equipped) - Frigidaire GLCS378DSA Use & Care Manual

Setting Warmer Drawer Controls
Arranging Warmer (Warm & Ready™) Drawer Rack Positions
The rack can be used in 2 ways:
• In the upright position to allow low profile food items to be placed both under
and on top of the rack (for example, rolls or biscuits on top of the rack and a
casserole dish underneath).
• In the downward position to allow you to place light weight food items and
empty dishware (for example, rolls or pastries and dinner plates) on the rack.
Set the Warmer Drawer Rack in either position as shown below (Figure 1).
Operating the Warmer Drawer
The purpose of the Warmer Drawer is to keep hot cooked foods at serving
temperature. Always start with hot food. It is not recommended to heat cold food in
the Warmer Drawer. All food placed in the Warmer Drawer should be covered with
a lid or aluminum foil to maintain quality. Do not use plastic wrap to cover food.
Plastic may melt onto the drawer and be very difficult to clean. Use only
utensils and cookware recommended for oven use in the Warmer Drawer.
Always use potholders or oven mitts when removing food from the
Warmer Drawer as cookware and plates will be hot and you can be burned.
Warmer Drawer Temperature Selection
Recommended Warmer Drawer settings table is shown in Figure 2. If a particular food
is not listed, start with the MED setting. If more crispness is desired, remove the lid
or aluminum foil from the food. Most foods can be kept at serving temperatures on
the MED setting. When a combination of foods are to be kept warm (for instance,
meat with 2 vegetables and rolls), use the HI setting. To avoid heat loss, do not open
the Warmer Drawer while in use.
To Set the Warmer Drawer Controls:
The control and indicator lights for the Warmer Drawer features are located on the
control panel. The temperatures are approximate, and are designated by HI (high),
MED (medium) and LO (low).
1. Touch the pad at the Warmer Drawer control position. The Warmer Drawer
indicator light will flash. Note: If no further pads are touched within 25 seconds
the request to power the Warmer Drawer ON will clear.
2. Set the desired power level. Touch
(see Figure 2) or to turn ON the power level for LO (see Figure 4). The Warmer
Drawer indicator light located beside the
3. Each touch of the
Figure 2) to MED (see Figure 3) to LO (see Figure 4). Note: For best results, preheat the Warmer
Drawer before adding the food . An empty drawer will preheat in approximately 15 minutes.
4. When the food is ready for removal, touch the
Warmer Drawer indicator light will turn OFF.
Note: The Warmer Drawer is inoperable
during the self-clean cycle.
Note: The warmer drawer is equipped with
a catch which may require extra force when
opening and closing the drawer.
once to turn ON the power level for HI
pad will turn ON steady.
or pads will decrease or increase through 6 power levels from HI (see
(If Equipped)
pad once to turn the Warmer Drawer OFF. The
Figure 2 Figure 3
10
Warmer Drawer Rack
in upward position
Warmer Drawer Rack
in downward position
Figure 1
Warmer Drawer recom-
mended Food Settings Table
Food Item
Bacon
Hamburger Patties
Poultry
Pork Chops
Fried Foods
Pizza
Gravies
Casseroles
Eggs
Roasts (Beef, Pork, Lamb)
Vegetables
Biscuits
Rolls, hard
Pastries
Rolls (soft)
Empty Dinner Plates
Figure 2
Figure 4
Figure 1
Setting
HI
HI
HI
HI
HI
HI
MED
MED
MED
MED
MED
MED
MED
MED
LO
LO