Setting The Audio Mix - Canon OPTURA200 MC Instruction Manual

Setting the Audio Mix

E
When you play back a tape that was recorded in 12-bit mode, you can set
the audio output to play: stereo 1 (the original sound), stereo 2 (any new
sound, dubbed to the tape after recording), or mix the balance between the
two.
• Audio from the 16-bit mode only contains stereo 1 sound and so you
cannot/do not need to select the audio mix. The same is true for the 12-bit
stereo 1 mode, unless new sound has been added post-recording.
+ PLAY
TAPE
(VCR)
Choose the output.
• Press AUDIO MONITOR on the wireless controller.
• Starting with the last selected setting, 4 settings appear as you push
the button:
– STEREO1 for just stereo 1.
– STEREO2 for just stereo 2.
– MIX/FIXED for an equal mix of stereo 1 and 2.
– MIX/VARI. (mix variable) for when you wish to mix the balance
between stereo 1 and 2.
• To simply choose STEREO1, STEREO2 or MIX/FIXED, make sure your
choice appears on the display.
• If you choose MIX/VARI., you can go on to mix the balance.
• Use the ST-1/ST-2 keys to mix the balance. A bar showing the mix
appears on the screen for 4 seconds.
Note:
• When you have chosen the output, STEREO1, STEREO2, MIX/FIXED or
MIX/VARI. is shown in the top left of the display for a few seconds. If you
turn the power off the output is set to STEREO1.
104
MIX
AUDIO
BALANCE
MONITOR
ST-1 ST-2
/ /