Analog/Digital Conversion - Canon HV20 Instruction Manual

Recording starts.
7
While recording, press
pause the recording.
In record pause, press
resume recording.
8
Press to stop recording.
9
Connected device: Stop the
playback.
IMPORTANT
Blank sections may be recorded as
anomalous picture.
If the picture does not appear, disconnect the
DV cable and restore the connection after a
short while or turn the camcorder off and then
on again.
Do not connect any devices to the
camcorder's USB terminal while an external
device is connected to the HDV/DV terminal.
You can only record video signals in HDV
standard (1080i specifications) or in DV
standard. Note that signals from identically
shaped DV (IEEE1394) terminals may be in
different video standards.
NOTES
We recommend powering the camcorder using
the compact power adapter.
Copyright Signal
Certain software tapes are copyright
protected. If you attempt to play back such
tapes, "COPYRIGHT PROTECTED
PLAYBACK IS RESTRICTED" appears and
you will not be able to view the contents of
the tape. If you attempt to record from such
tapes via the HDV/DV terminal,
"COPYRIGHT PROTECTED DUBBING
RESTRICTED" appears and you will not be
able to record the contents of the tape.

Analog/Digital Conversion

to
/
Using the camcorder you can convert
again to
/
analog video signals (for example from a
VCR) to digital signals (DV standard only)
and output them to a digital recording
device.
Connecting
Connect the camcorder to the video input
source using an analog connection
–connection type
previous section Connection Diagrams.
Connect the camcorder to the recording
device using the digital connection
–connection type
same section. Verify that the DV terminal on
the external digital device is compatible with
the DV standard.
Converting the Video
FUNC.
(
1
Set [AV
2
Start the playback on the video
source and the recording on the
recording device.
Refer to the instruction manuals of the
connected devices.
Depending on the signal sent from the
connected device, the conversion from analog
to digital signals might not work properly (e.g.,
signals that include copyright protective signals
or anomalous signals such as ghost signals).
Usually, leave [AV
setting [
you cannot connect video input signals to the
camcorder using the HDV/DV terminal.
Connecting to a TV or VCR
(
66
4
(
66
2
23)
DV] to [
IMPORTANT
DV] set to the default
OFF]. While it is set to [
73
( 10)
)
– shown in the
)–
shown in the
ON] ( 39).
ON],