General Cleaning; Cleaning Various Parts Of Your Cooktop - Frigidaire FGC36S6ASC Use & Care Manual

Frigidaire fgc36s6asc: user guide
Hide thumbs Also See for FGC36S6ASC:
Table of Contents

Advertisement

General Cleaning

Cleaning Various Parts of Your Cooktop

Before cleaning any part of the cooktop, be sure all controls are turned OFF and the cooktop is COOL. Remove spillovers and
heavy soiling as soon as possible. Regular cleaning will reduce the number of major cleaning later.
Surfaces
Aluminum (Trim Pieces) &
Vinyl
Glass, Painted and Plastic
Control Knobs, Body
Pieces, and Decorative Trim
Control Panel
Stainless Steel, Chrome
Decorative Trim
Porcelain Enamel
Burner Grates, Burner Pans
(some models), Burner Rings
(some models), Cooktop
Surface
Surface Burners
How to Clean
Use hot, soapy water and a cloth. Dry with a clean cloth.
For general cleaning, use hot soapy water and a cloth. For more difficult soils and built-up
grease, apply a liquid detergent directly onto the soil. Leave on soil for 30 to 60 minutes.
Rinse with a damp cloth and dry. DO NOT use abrasive cleaners on any of these materials;
they can scratch.
Before cleaning the control panel, turn all controls to OFF and remove the control knobs. To
remove, pull each knob straight off the shaft. Clean using hot, soapy water and a cloth. Be
sure to squeeze excess water from the cloth before wiping the panel; especially when
wiping around the controls. Excess water in or around the controls may cause damage to
the appliance. To replace knobs after cleaning, line up the flat sides of both the knob and
the shaft; then push the knob into place.
Gentle scouring with a soapy nylon pad will remove most spots. Rinse with a 1:1 solution of
clean water and ammonia. Cover difficult spots with an ammonia soaked paper towel for
30 minutes, scrub with a nylon pad and rinse with clean water. Cleaners made especially for
stainless steel or chrome are recommended. Bluish stains on these materials are caused by
overheating and cannot be removed. Remove all cleaners or the finish may be damaged
during future heating. DO NOT use spray oven cleaners on the cooktop.
Gentle scouring with a soapy nylon pad will remove most spots. Rinse with a 1:1 solution of
clean water and ammonia. If necessary, cover difficult spots with an ammonia-soaked
paper towel for 30 to 40 minutes. Rinse with clean water and damp cloth, then scrub with
a soap-filled scoring pad. Rinse and wipe dry with a clean cloth. Remove all cleaners or the
porcelain may become damaged during future heating. DO NOT use spray oven cleaners
on the cooktop.
The holes in the burners of your cooktop must be kept clean at all times for proper ignition
and a complete, even flame. Clean the burner holes routinely with a small gauge wire or
needle and especially after bad spillovers which could clog these holes.
To remove and replace burner units per your model, see instructions under General
Cleaning. To clean, soak the burners in a 1:1 solution of ammonia and water for 30 to 40
minutes. For stubborn stains, scrub with soap and water or a mild abrasive cleanser and
damp cloth. Dry the burners thoroughly in a warm oven for 30 minutes. Then replace them,
making sure they are seated and level. DO NOT wash burner units in the dishwasher.
9

Advertisement

Table of Contents
loading

Table of Contents