Returning to a Pre-Marked Position
E
OFF
CAMERA
VCR
Use the wireless controller to go back to a pre-determined point on a tape following playback.
1. Press the ZERO SET MEMORY button on the wireless controller at a point you want
to return to later.
• The time code is replaced by a tape counter that is set to zero with the  indication.
• Press the ZERO SET MEMORY button once more to cancel the zero set memory.
2. When you have finished playback, fast forward or rewind the tape. The tape stops
automatically when it reaches the zero set position.
• RTN1 or `RTN appears in the display.
• The tape counter with  indication disappears from the display and the time code reappears.
Notes:
• The zero set memory may not function correctly where there is a break between recordings on the tape.
• You can also use zero set memory to mark a position on a tape in record pause mode. When you then
play back the tape, pressing rewind will take you back to the pre-marked position.
• There may be a slight difference between the timecode and the tape counter readings.
• If you remove the tape while the zero set memory is set, the memory is canceled and the tape counter
reverts to timecode.
• The camera remembers your setting even if you slide the POWER switch to OFF.
68
POWER
REC
SEARCH
PAUSE
SELECT
ZERO SET
REW
PLAY
FF
MEMORY
AUDIO
STOP
– /
+ /
DUB.
A/V
PAUSE
SLOW
2
INSERT