Frigidaire FES367FCC Use & Care Manual page 11

Drop-in / slide-in models
Hide thumbs Also See for FES367FCC:
Table of Contents

Advertisement

Models with Ceramic Glass Cooktop
(continued)
Operating the Dual Surface Radiant Element
(Models with Ceramic Glass Cooktop Only)
Model A is equipped with Dual radiant surface elements at all
positions (See Figure 8). Models B & C are equipped with a
dual radiant surface element located at the right front (See
Figures 9 & 10) position. Symbols on the control panel are
used to indicate which coil of the dual radiant element will heat.
The
symbol indicates that only the inner coil will heat
(Figures 1, 3,4 and 5). The
and outer coils will heat (Figures 6, 8, 9 and 10). You may
switch from either coil setting at any time during cooking.
To Operate the Dual Surface Element:
1. Place correctly sized cookware on the dual surface
element.
2. Push in and turn the control knob counterclockwise (See
Figure 2) for smaller cookware or clockwise (See Figure 7)
for larger cookware.
3. Turn the knob to adjust the setting if needed. Start most
cooking operations on a higher setting and then turn to a
lower setting to finish cooking. Each surface element
provides a constant amount of heat at each setting. A
glowing red surface heating area extending beyond the
bottom edge of the cookware indicates the cookware is
too small for the surface heating area.
4. When cooking has completed, turn the surface control
knob to OFF before removing the cookware. Note: The
Surface Indicator light will come on when the control knob
will be turn on and will continue to glow until the glass
cooktop has cooled down to a moderate level. The light
may remain on even though the controls are turned OFF.
Note: See page 9, Figure 1 for recommended control settings.
Radiant surface elements may appear to have
cooled after they have been turned off. A hot surface indicator
light will come on and will continue to glow until the glass
cooktop has cooled down to a moderate level. The glass
surface may still be hot and burns may occur if the glass
surface is touched before the indicator light has turned off.
Setting Surface Controls
symbol indicates that both inner
Small
Element
Figure 1
Small
Large
OFF
Petit
Grand
hi
hi
6
4
2
lo
lo
Figure 2
Figure 3 - Model A
Figure 4 -Model B
Figure 5 -Model C
11
Large
Element
Figure 6
Small
OFF
Petit
hi
6
6
4
4
2
2
lo
Figure 7
Figure 8 - Model A
Figure 9 - Model B
Figure 10 - Model C
Large
Grand
hi
6
4
2
lo

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents