Setting The Data Code - Canon Elura 2 Instruction Manual

3_ELURA2_E(33-79)

Setting the data code

E
You can also choose to display camera data (shutter speed and exposure settings)
in cassette data codes.
VCR
( 34)
To change, open the menu and select DISP.SET UP. Then select DATA
CODE, set it to DATE/TIME, CAMERA DATA or CAM. & D/T and close
the menu.
Possible data code combinations:
D/TIME SEL.
Date
Time
Date & Time
• The data code will read "– – –" in the following situations:
– During playback of a blank section of tape.
– If the tape was recorded before entering the date and time in the camera's
memory.
– If the tape was recorded on a camera without a data code function.
– If noise or tape damage prevents the data code from being read.
• If a recording made on ELURA2/ELURA2 MC is played back on a different
DV camcorder, the data code may not be displayed correctly.
• The data code will appear in the display even if DISPLAYS (
set to OFF through the menu.
76
7/25/00 17:10 Page 76
DATA CODE
(cassette
Date/Time
only)
Date/Time &
Camera data
Camera data
2
132) has been