Communication And Power Cables - LG Multi V ARUV100LTS4 Installation Manual

Communication and Power Cables

Communication cable
- Types : shielding cable
- Cross section : 1.0~1.5mm
- Maximum allowable temperature: 60°C
- Maximum allowable cable length: under 1000m
Remote control cable
- Types : 3-core cable
Central control cable
Product type
ACP&AC Manager
AC Smart
Simple central controller
Separation of communication and power cables
- If communication and power cables are run alongside each other then there is a strong likeli-
hood of operational faults developing due to interference in the signal wiring caused by electro-
static and electromagnetic coupling.
The tables below indicates our recommendation as to appropriate spacing of communication
and power cables where these are to be run side by side
Current capacity of power cable
100V or more
NOTE
!
• The figures are based on assumed length of parallel cabling up to 100m. For length in ex-
cess of 100m the figures will have to be recalculated in direct proportion to the additional
length of cable involved.
• If the power supply waveform continues to exhibit some distortion the recommended
spacing in the table should be increased.
- If the cable are laid inside conduits then the following point must also be taken into ac-
count when grouping various cable together for introduction into the conduits
- Power cable(including power supply to air conditioner) and communication cables
must not be laid inside the same
- In the same way, when grouping the power wires and communication cables should not
be bunched together.
CAUTION
!
If apparatus is not properly earthed then there is always a risk of electric shocks, the earthing of
the apparatus must be carried out by a qualified person.
2
Cable type
2-core cable (Shielding cable)
2-core cable (Shielding cable)
4-core cable (Shielding cable)
10A
50A
100A
Exceed 100A
ELECTRICAL WIRING
Diameter
2
1.0~1.5mm
2
1.0~1.5mm
2
1.0~1.5mm
Spacing
300mm
500mm
1000mm
1500mm
55