Paper Does Not Feed Properly - Canon PIXMA MX310 series Quick Start Manual

Cause
The machine is not ready.

Paper Does Not Feed Properly

Cause
Printing on inappropriate type of paper.
Paper feed roller is dirty.
Paper not loaded properly.
Too much paper loaded.
Foreign object in the Rear Tray.
Envelopes not prepared nor loaded
properly.
Check if the Power lamp is lit green.
If the Power lamp is off, turn the machine on.
While the Power lamp is flashing green, the machine is initializing. Wait until the
Power lamp stops flashing and remains lit green.
Note
When printing large data such as a photo or graphics, it may take longer to start
printing.
Check to see if the paper you are printing on is not too thick or curled.
See "Media Types You Cannot Use" on page 13.
Clean the paper feed roller. Cleaning the paper feed roller will wear the roller, so
perform this procedure only when necessary.
For details on cleaning, see "Cleaning the Paper Feed Roller (Roller Cleaning)"
on page 74.
Make sure of the following when you load paper in the machine.
When loading two or more sheets of paper, align the edges of the sheets
before loading.
Always load the paper in portrait orientation in the Rear Tray, regardless of
the printing orientation.
Load the paper with the print side facing UP. Align the paper stack against
the right side of the Rear Tray and slide the Paper Guide so that it just
touches the left edge of the stack.
For details on loading paper, see "Loading Paper" on page 14.
Make sure that the paper stack does not exceed the load limit. However, proper
feeding of paper may not be possible at this maximum capacity depending on
the type of paper or environmental conditions (either very high or low
temperature and humidity).
In such cases, reduce the sheets of paper you load at a time to around half.
For details on loading paper, see "Loading Paper" on page 14.
Make sure that there are no foreign objects in the Rear Tray.
When printing on envelopes, see "Loading Envelopes" on page 16, and
prepare the envelopes before printing.
Once you have prepared the envelopes, load them in the machine in portrait
orientation. If the envelopes are placed in landscape orientation, they will not
feed properly.
Set the Paper Thickness Lever to the right.
Action
Action
Troubleshooting 89