TELETRAC NAVMAN Qtanium200 Installation Manual page 24

Qtanium200 mounting location
• All equipment and wiring must be installed in a manner that will conceal its location.
• It is always best to mount the unit to a flat surface; it should not be mounted on curves, dips or humps since this can degrade the security of the
unit.
• Mount the unit to the chassis of the vehicle utilizing the mounting tabs. Always secure the unit with screws or zip-ties.
• Always check behind the place where any screws will penetrate to make sure you are not going to drill into a fuel or brake line, wiring harness,
etc.
• Be careful when mounting touching an existing factory harness because vibration may cause an electrical short. Great care must be taken to
prevent chaffing.
• Mount the unit in a location that will provide the internal antenna a clear view of the sky.
• Mount the unit so it will not cause any physical interference with the normal operation of movable equipment in the vehicle such as seats,
pedals, hinges, air conditioning vents, etc.
•
Never mount any component to vehicle air lines. Damage to the air lines will cause a catastrophic failure disabling the use of the vehicle.
24