Table of Contents
Advertisement
2. Introduction
The table setting tool is software to set the function and operation of the "PLC software for general equipment
control (Ver.2)." This tool is used to create setting files that contain such settings as input/output-related settings
and output method settings for each facility. These files are then written in on the ATA card and are used by the
PLC for general equipment control to perform its control functions (Interlock control). No settings with the table
setting tools are required if the PLC software for general equipment control is used only for general equipment
control and schedule control without the interlocking control function being used, unless changes to the
operating output format to the general equipment are made.
2-1
About This Manual
• This instruction book describes the Table Setting Tool to set the operating function of the "PLC software
for general equipment control (Ver.2)."
*This table setting tool is applicable to Ver. 2 of the "PLC software for general equipment control."
Model : PAC-YG21CDA (Ver.2 series)
Table
Setting Tool
Ver.1.10
Ver.1.20
Ver.1.30
(the latest) Display in Fahrenheit*2
*1: Not available in this combination. Use the latest version of PLC in combination with the latest version of Table Setting Tool.
*2: The temperature unit displayed must be the same in one system.
• Some screens used in this Manual provide just an image differing from actual appearance.
• Unless otherwise specified, "G-50A" in this manual refers to both "G-50A" and "GB-50A".
2-2
Expressions in This Manual
• Unless designated, Windows® 2000 Professional and Windows® XP are expressed as [Windows].
* Windows is a registered trademark or trademarks of Microsoft Corporation in the United States and/or other countries.
• "Click" refers to the action of positioning the mouse cursor on the object (such as button or folder) and
pressing down and releasing the left mouse button once. "Double click" refers to the action of pressing
down and releasing the left mouse button twice in quick succession.
• PLC refers to the Programmable Logic Controller.
2-3
Required Materials and Hardware Requirement
• The following materials are required to install the data being set by this table setting tool in the assigned
ATA card.
Table 2-2 Materials required by operating table setting tool
Item
Setup CD-ROM
ATA card
For PC ATA card
adapter
Computer
• To operate the table setting tool of PLC for general equipment control, the PC to be installed should
satisfy the following requirement.
Table 2-1 Available version of table setting tool
PLC
Display in Centigrade*2
Display in Centigrade*2
Display in Centigrade*2
Master CD of the PLC software for
general equipment (PAC-YG21CDA)
Q2MEM-8MBA
(The ATA card in which PLC software was written
after the format.)
Q2MEM-ADP
Refer to Table 2-3.
PAC-YG21CDA
From Ver.2.00
to Ver.2.11
(the latest)
V
V
V
-(*1)
Details
2
[V]: Available
Remarks
Ver.2.20
V
V
V
*G-50A and indoor
units that have 1ºF
V
temperature setting
function are required.
(Refer to page 17.)
Remarks
* Table setting tool contained by
mentioned CD is used.
1 piece is required by 1 set of
PLC. Mitsubishi Electric made.
Writing ATA card
For ATA card writing
*PCMCIA slot is needed
Advertisement
Table of Contents
