Aappendix - Mitsubishi Electric FR-F840-00023 Installation Manuallines

A APPENDIX
A.1 Instructions for Compliance with the EU Directives
The EU Directives are issued to standardize different national regulations of the EU Member States and to facilitate free
movement of the equipment, whose safety is ensured, in the EU territory.
Since 1996, compliance with the EMC Directive that is one of the EU Directives has been legally required. Since 1997,
compliance with the Low Voltage Directive, another EU Directive, has been also legally required. When a manufacturer
confirms its equipment to be compliant with the EMC Directive and the Low Voltage Directive, the manufacturer must
declare the conformity and affix the CE marking.
The authorized representative in the EU
The authorized representative in the EU is shown below:
Name: Mitsubishi Electric Europe B.V.
Address: Mitsubishi-Electric-Platz 1, 40882 Ratingen, Germany
A.1.1 EMC Directive
We declare that this inverter conforms with the EMC Directive and affix the CE marking on the inverter.
EMC Directive: 2014/30/EU
Standard(s): EN61800-3:2004+A1:2012 (Second environment / PDS Category "C3")
This inverter is not intended to be used on a low-voltage public network which supplies domestic premises. When using
the inverter in a residential area, take appropriate measures and ensure the conformity of the inverter used in the
residential area.
Radio frequency interference is expected if used on such a network.
The installer shall provide a guide for installation and use, including recommended mitigation devices.
NOTES
First environment
Environment including residential buildings. Includes buildings directly connected without a transformer to the low
voltage power supply network which supplies power to residential buildings.
Second environment
Environment including all buildings except buildings directly connected without a transformer to the low voltage
power supply network which supplies power to residential buildings.
NOTES
Set the EMC filter valid and install the inverter and perform wiring according to the following instructions:
The inverter is equipped with a built-in EMC filter. Set the EMC filter valid. (For details, refer to the FR-F800 and FR-
CC2 Instruction Manuals.)
Connect the inverter (and the converter unit) to an earthed power supply.
Install a motor and a control cable according to the EMC Installation Guidelines (BCN-A21041-204) and Technical
News (MF-S-114, 115) according to the instruction.
To ensure sufficient function of the built-in EMC filter, motor cable lengths should not exceed more than 20m.
Confirm that the inverter (and the converter unit) conforms with the EMC Directive as the industrial drives application
for final installation.
52