Table of Contents
Advertisement
How to View Waveforms
HP 81200 Data Generator/Analyzer Platform User Guide, Revision 2.1
How to View Waveforms
Generated, expected and captured data can be displayed in graphical form
with the Waveform Viewer.
How to Start the Waveform Viewer
To open the Waveform Viewer:
1 Click the Waveform Viewer icon of the tool bar.
Alternatively, you can also open the View menu and choose Result
Displays.
The Waveform Viewer identifies the test sequence and the ports:
Figure 105
Waveform Viewer Selection Window
If you select a data block of the test sequence or a pulse port, generated
and expected data will be displayed in time mode. The available
resolution is the blocklength granularity, the unit is nanoseconds (ns).
This enables you to check the delays that have been set up. Note that
PRBS/PRWS data cannot be displayed in time mode.
If you select a DUT output port (= analyzer input), the data will be
displayed in sample mode. This corresponds to the way the data has
been acquired. The total number of samples is the number of captured
vectors times the maximal factor of the FMR (see "FMR and Blocklength
Granularity" on page 31).
2 Choose from the menu.
Viewing Generated and Captured Data
193
Advertisement
Table of Contents
