Table of Contents
Advertisement
Smart Array 6404 Controller HP-UX Installation
Setting up a Smart Array 6404 Controller As a Boot Device
unlimited inodes, largefiles not supported
15625 data blocks, 14529 free data blocks
1 allocation units of 32768 blocks, 32768 data blocks
last allocation unit has 15625 data blocks
* Loading mount to mount/dev/ram1 file system...
* Mounting /dev/ram1 file system succeeded!
* Copying /dev.old files back to /dev succeeds!
* Loading insf to create disk device files...
* Creating disk device files...
* Loading in a shell...
NOTE:
Pushing a shell, you will have to use "reboot" to reboot the system when done.
"loadfile" command to bring in more commands as you need them.
#
Step 3. At the recovery shell prompt, enter:
loadfile -l INSTCMDS/opt/raidsa/bin/ciss_insf
# loadfile -l INSTCMDS /opt/raidsa/bin/ciss_insf
#
Step 4. At the next prompt, enter:
/opt/raidsa/bin/ciss_insf
and verify that the device file for the Smart Array 6404 Controller has been created.
# /opt/raidsa/bin/ciss_insf
Installing special file for Smart Array 6404
/dev/ciss3 installed
#
Step 5. At the prompt enter:
loadfile -l INSTCMDS /opt/raidsa/bin/saconfig
# loadfile -l INSTCMDS /opt/raidsa/bin/saconfig
#
Step 6. Configure the array(s) and logical drive(s) following the instructions for the saconfig configuration
utility. The entire path /opt/raidsa/bin/saconfig /dev/cissX needs to be entered for saconfig
to run.
Step 7. Once the logical drive(s) and array(s) have been configured, exit the recovery shell by entering
reboot at the prompt. The system will reboot and you will be returned to the Boot Console Handler
(BCH) prompt.
Step 8. At the BCH prompt, start Ignite-UX from the HP-UX 11i v1 Core OS Install and Recovery Media.
The Ignite-UX "Welcome" screen displays (see Step 1).
Step 9. Select "Install HP-UX".
14
Use the
Chapter 1
Advertisement
Table of Contents
