Continuous Firing; Preparing A Battery (Optional); Loading Batteries; Attaching To The Camera - Panasonic DMW-FL200LE Operating Instructions Manual

Continuous Firing

The flash may become hot when fired many times in
succession, resulting in damage or malfunction. The flash
should be fired no more than 10 times in succession at
intervals of 2.5 seconds, after which it should be left unused
for at least 10 minutes.

Preparing a Battery (optional)

Choose from the below batteries:
≥ LR6/AA Alkaline dry batteries (k 2)
≥ HR6/AA Rechargeable nickel metal hydride batteries
(Ni-MH) (k 2)
R6/AA Manganese dry batteries cannot be used.
The use of batteries made by Panasonic is recommended.

Loading Batteries

≥ Use alkaline dry batteries or rechargeable nickel metal
hydride batteries.
1 Rotate the flash head.
2 Slide the lever in the
direction of [2 OPEN] to
open the battery cover.
3 Insert the batteries over
the ribbon (A) with correct
[r]/[s] polarity.
• You can easily take out the
batteries by pulling the ribbon.
4 Close the battery cover
until it clicks into place.
• Close the battery cover so that the ribbon does not stick
out.

Attaching to the Camera

Confirm that both the camera and flash are off. Attaching or
removing the flash while either the flash or the camera is on
may result in malfunction.

1 Slide the lock lever in the direction
opposite to that indicated by the [LOCK 1]
icon (1).
2 Slide the flash into the hot shoe until it
clicks securely into place (2).
3 Slide the lock lever to the [LOCK 1]
position (3).
≥ To remove the flash, slide the lock lever in the direction
opposite to the [LOCK1] arrow and slide it from the shoe.



SQT1378
7