LG GSA-H58N Owner's Manual page 9

To Install as a Slave Drive
To install the drive as a Slave, change the jumper setting on the rear panel to SL.
Master drive
(Booting hard disk)
Slave drive
(Super Multi
DVD Rewriter)
(Jumper set to
Slave)
Connecting the Power Connector
Connect the power cable from the computer's power supply to the socket on the drive
unit, fitting the connector firmly into the power in connector. If there is no spare power
cable available in the computer, you will have to purchase a splitter cable of a suitable
type.
Beveled edge up
Connecting the Interface Connector
Connect the 80-pin IDE cable to the back of the Super Multi DVD Rewriter, making
sure the coloured (red) stripe on the IDE cable is connected to pin 1 on the Super
Multi DVD Rewriter (Pin 1 is closest to the Power Connector).
Pin1
Red-edge
Master drive
Master drive
(Booting hard disk)
(Other IDE drive)
- OR -
Primary
connector
NOTE : Improper connection may
damage the drive and void the warranty.
Generally, the power connector can only
fit one way.
NOTE : Generally, the IDE connector is
keyed and will only fit one way.
Replacing the Computer Cover
When the installation of the drive unit is
complete, replace the computer cover.
6
Slave drive
(Super Multi
DVD Rewriter)
(Jumper set to
Slave)
Secondary
connector